Clean the surface, ensure all traces of tar, oil and grease have been removed then clean with isopropyl alcohol. Surface must be very clean.
Measure and position graphics , taping at the top edge to form a hinge.
Check positioning from a distance.
Squeegee down masking tape.
You can use credit card for
squeegeeing
Squeegee any small graphics to ensure it stay on the application tape when the backing is removed.
Remove backing slowly by peeling back against its self. Ensure all the graphics stays with the application tape.
Tension tape so that it is flat and hold it at about 15 degrees to the surface.
Begin to carefully squeegee at a medium pressure. Start from the top middle systematically toward the edges holding the squeegee at 45 deg to the already stuck line to ensure no air is trapped under the media.
A helper may be required.
If he wants beer just give to him
because this is most important
Once all the media is down carefully work out any bubbles before going over all the letters with the squeegee as hard as you can without tearing the application tape, it might pay to hold the backing over the area being worked(shiny side up) to help the squeegee slide.
Remove the application tape by peeling back against the vehicle, You should now find out if you've cleaned and squeegee well enough.
